Page 173 - ZF-Catalog-ZSi-Foster-08-19-R3

FCH
Flange Clip
FCH
FCH S w/Stud
1⁄4"-20 x 3⁄8" Stud
• Multi use beam clamp used to support threaded rod, electrical boxes, and bridal rings from beam flanges.
• Beam clamp with stud is for supporting electrical boxes from beam flanges.
• Punched holes provided for zip tie applications.
• 1⁄4"-20 thread forms permit threaded rod applications. • Only a hammer required for installation.
• Material: Spring Steel • Finish: Silva-Guard
Structural Attachment Standard Finish: Silva-Guard (SG)
30 lbs.
120 lbs.
80 lbs.
30 lbs.
120 lbs.
80 lbs.
* Loads are static load limits and should not be combined.
Part No.
Flange Thickness
FCH24
1⁄8" - 1⁄4" (3mm - 6mm)
FCH58
5⁄16" - 1⁄2" (8mm - 13mm)
FCH912
9⁄16" - 3⁄4" (14mm - 19mm)
FCH24S
1⁄8" - 1⁄4" (3mm - 6mm)
FCH58S
5⁄16" - 1⁄2" (8mm - 13mm)
FCH912S
9⁄16" - 3⁄4" (14mm - 19mm)
FSM
Flange Clip Side Mount
220 lbs 220 lbs
Part No.
Flange Thickness
Hole Size
FSM24
1⁄8" - 1⁄4" (3mm - 6mm)
9⁄32"
(7.1mm)
FSM58
5⁄16" - 1⁄2" (8mm - 13mm)
FSM912
9⁄16" - 3⁄4" (14mm - 19mm)
ZSi-Foster Engineering Catalog
– 173 –
• Beam clamp with hole for supporting tie wire and jack chain to beam flanges.
• Only a hammer required for installation. • Material: Spring Steel
• Finish: Silva-Guard
WARNING: These products can expose you to chemicals including lead, which is known to the State of California to cause cancer, and which is known to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Technical Gamma Rooftop Concrete Beta Clamps Loop & Ring Spring Electrical Pipe & Conduit General Channel Nuts Channel Introduction Data Pads Supports Inserts & Z-Clamps Clamps Steel Fittings Supports Fittings & Hardware