Page 256 - ZSi-Foster Engineering Catalog - Electronic Version 2
P. 256

 • Standard-Series
• Twin-Series (T1 Only)
• Beta Rubber Inserts
Beta Clamp Installation
   Installation on Wesanco Channel
The ZSA Nuts can be used with any clamp using a 1/4-20 mounting bolt. This includes:
Multi-Level Assembly
ZSi multi-level pipe clamps permit easy stacking of several tubes or pipes of the same group. The clamps are connected by stacking bolts.
Safety plates are inserted between the clamps to prevent the stacking bolts from turning.
The example below shows a stacking clamp added to a welded clamp, however, ZSi stacking assemblies can be fitted to weld plates, rails, or strut in the same manner.
(1) After the Top Cushion is Added, Secure it with the Stack Bolts
(2) Add Safety Plate to Prevent Stacking Bolts from Turning
 (1) Insert ZSA Nuts Into Wesanco Channel And Turn to Lock
(2) Push Bottom Half
of Clamp Onto ZSA Nuts
       (3) Install Pipe
(4) Add Top Cushion
 (3) Assemble Another Clamp Onto the Stacking Bolt in
Same Manner as Single Clamps are Installed
 (5) Add Top Plate and Bolt Into Position
 – 256 –
NOTE: The ZSA Nut will slide within the Wesanco Channel so clamp units can be adjusted before being firmly bolted.

   254   255   256   257   258