Page 113 - ZSi-Foster Engineering Catalog - Electronic Version 2
P. 113

Flange To Flange Clamp
W5741 - W5745
Beam Clamps
Beam Clamps
Standard Finish: Electro Galvanized (EG)
   Strut (not included)
Cut W200 1-1⁄2" less
than inside flange dimension.
Set Screw Included
     All Rods are shown with jamb nuts or “Locking” provision as recommended
W5760 53 (24 Kg)
800 (3.56 kN)
3⁄4" (19mm)
1-1⁄16" (27mm)
Adjusting Screws Included
“Bottom Rod” Against Beam (Recommended)
W5741 3⁄8"
W5742 1⁄2"
W5743 5⁄8"
W5744 3⁄4"
W5745 7⁄8"
Swivel Hanger
Rod Size
400 (1.78 kN) 500 (2.22 kN) 550 (2.45 kN) 600 (2.67 kN)
900 (4.00 kN)
 Part No.
  Rod Size
  Allowable Load Lbs. (kN) (ea.)
     Part No.
  Wt. Lbs/C
  Allowable Load Lbs. (kN)
        Allowable load capacity for both horizontal and vertical loads
All Purpose Beam Clamp
300# Locknut in First Hole
2 Holes 9⁄16" Dia.
500# Locknut in Second Hole
Includes 3⁄8" x 13⁄4" bolt and nut
Includes 3⁄8" x 13⁄4" bolt and nut
For Hanging 1/4" or 3/8" Rod at a 20° swivel
         Provides for hanging 1⁄4" or 3⁄8" rod with 20° 131 1
Provides for hanging rod directly below set screw.
Alternate use provides ⁄4", ⁄8" or ⁄2" rod to be extended from
the top to the bottom of the clamp on the end opposite the set
11 screw. ⁄4" flat washer must be used with ⁄4" rod.
ZSi-Foster Engineering Catalog
swivel or ⁄2" rod without swivel.
1⁄4" flat washer must be used with 1⁄4" rod.
 It is recommended that the beam be dimpled at set screw contact location(s)
– 113 –
 WARNING: These products can expose you to chemicals including lead, which is known to the State of California to cause cancer, and which is known to cause birth defects or other reproductive harm. For more information go to
                 Technical Gamma Rooftop Concrete Beta Clamps Loop & Ring Spring Electrical Pipe & Conduit General Channel Nuts Channel Introduction Data Pads Supports Inserts & Z-Clamps Clamps Steel Fittings Supports Fittings & Hardware

   111   112   113   114   115