Page 112 - ZSi-Foster Engineering Catalog - Electronic Version 2
P. 112

   W5702 to W5705
Beam Clamps
Standard Finish: Electro Galvanized (EG)
W5709
"U" Bolt Beam Clamp (Short) (Used In Pairs)
 Beam Clamp (Used In Pairs)
Set Screw Included
 7⁄8"
22mm
13⁄4"
1⁄4"
6mm
  45mm
     Used with 15⁄8" Strut
3"
76mm
  A
(Used in Pairs)
1,000
(4.45 kN)
  Part No.
  Use With Channel
  Allowable Load Lbs. (kN)
    1⁄4"
31⁄2"
W5709
W5761 Series
W200, W210, W501, W300
 W5702
W5703
W5705
480
(2.14 kN)
229mm - 305mm 127mm
1⁄4"
6mm
3⁄8" 10mm
6mm
89mm
  Part No.
  A
  Use With Channel
  Allowable Loads Lbs. (kN)
  3-1⁄2" (89mm)
3-1⁄4" (83mm)
2-11⁄16" (68mm)
"U" Bolt Beam Clamp (Long) (Used In Pairs)
7⁄8"
22mm
1⁄4"
6mm
3"
76mm
W5708
– 112 –
W200, W210
W300
W500
U-Bolt Beam Clamp with J-Bolt
9" - 12"
       W5708
5"
 3"
76mm
W201
  W5761PBH Only
    W575556CLIPS
• 1" Max. Flange Thickness
Dia. J-Bolt
     5"
127mm
• For use with 1-5⁄8" to 3-1⁄4" high channel (W150)
• Recommended Torques: U-Bolt Nuts 150 in-lbs J-Bolt Nut 60 in-lbs
  Part No.
  Use With Channel
  Allowable Load Lbs. (kN)
  Part No.
  For Flange Width
  Use With Channel
   W100, W150, W201
1,000
(4.45 kN)
W5761
W5761-9
W5761-12
4" thru 5-7⁄8" (102 thru 149mm)
6" thru 9" (152 thru 229mm)
9" thru 12" (229 thru 305mm)
W150, W201
     Uniform loads are based upon opposing style clamps used in pairs, installed against the flanges of the beam. It is recommended that the beam be dimpled at set screw contact location(s)
WARNING: These products can expose you to chemicals including lead, which is known to the State of California to cause cancer, and which is known to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
www.zsi-foster.com
  






   110   111   112   113   114