Page 10 - ZF Beta Hydraulic Clamps

INSTALLATION ON WELD PLATES
ZSi-Foster weld plates are available for the following Series:
• Standard Series • Heavy Series
• Twin Series
• Beta Adapters
For best alignment of ZSi-Foster clamps we recommend that you mark their location before welding.
INSTALLATION ON MOUNTING RAILS
ZSi-Foster mounting rails can be used with the following Series:
• Standard Series
• Heavy Series (Group H3 to H6) • Twin Series
• Beta Adapters
ZSi-Foster mounting rails are available in two different height sizes and are either welded or bolted to the supporting construction.
For Standard Series and Twin Series insert hexa- gon rail nut and turn to lock. For Heavy Series slide in rail nut.
INSTALLATION ON CHANNEL
The ZSA Nuts can be used with any clamp using a 1⁄4-20 mounting bolt. This includes:
Beta Clamp Installation
• Standard Series
• Twin Series (T1 Only) • Beta Rubber Inserts
(1) Weld Plate to Supporting Steel
(1) Insert Appropriate Rail Nut and Turn to Lock
(1) Insert Strut Nuts Into Strut Channel And Turn to Lock
(2) Push Bottom Half
of Clamp Onto Strut Nuts
(2) Push Bottom Half of Clamp Onto Plate
(2) Push Bottom Half of Clamp Onto Plate
(3) Install Pipe
(3) Install Pipe
(3) Install Pipe
(4) Add Top Cushion
(4) Add Top Cushion
(5) Add Top Plate and Bolt Into Position
(5) Add Top Plate and Bolt Into Position
(4) Add Top Cushion
Installation On Weld Plates
• Weld metal welding plates to a weight adjusted base.
• Clip lower half of clamp on to welding plate and insert tube; then add second clamp-half, cover plate, and tighten with screws provided.
• DO NOT weld with plastic clamp in position.
• After assembly the two clamp halves MUST
NOT come into contact with each other.
(5) Add Top Plate and Bolt Into Position
– 10 –
www.zsi-foster.com
NOTE: The rail nut will slide within the rail so clamp units can be adjusted before being firmly bolted.
NOTE: The ZSA Nut will slide within the Channel so clamp units can be adjusted before being firmly bolted.